Ansonia antique Light Brown oak wall regulator by the Ansonia Clock Co., of Brooklyn NY. It is 100% original and has been completely restored. Condition is near mint. They just don't get any nicer, Circa 1900. Clock is 22" long, 14 1/2" wide, 4 1/2" deep. Check out our other listings we have several other School House Regulators listed. The perfect original dial on this clock is 9" in diameter minute track to minute track, 10" overall. Movement is original to the case. Clock has original dial, bezel, upper and lower glasses, pendulum, and old key marked Ansonia. There is also nice old label inside the case.
The Following Restoration Was Preformed.
Case has been professionally refinished, rubbed out between coats and three layers of cabinet wax applied. The quarter sawn oak veneer is mint less one small spot where the bezel catch closes. If it wasn't for this one small infraction it would be considered mint. The grain is amazing . The color is a light brown oak and the finish is between satin and semi gloss. It is not shiny, but rather has a nice warm glow.
All brass was polished and sealed. The signed Ansonia movement is original to the case. The four movement feet were repositioned by a previous repair person. The additional 4 holes line up to the movement feet when rotated. It would have been more correct to plug the old holes and re-drill them. The Ansonia clock movement is an unusual off set movement.
All Brass parts polished and sealed, just as it was done over 100 years ago. I am a purest and believe in preserving as much as humanly possible. The Value for Good Antiques is in Originality and Condition. Not Damaged, Broken, or comprised of non-original parts and overall dirty condition. Good Original Restored Antique Clocks have increased in value by leaps and bounds. Where-as non original unrestored clocks have not increase in value and are pretty much the same value they were years ago. 40 years ago it was fronded upon to restore an original dial, refinish the case and a factory label was missing. Now due to the lack of good original clocks these things have become acceptable and will not alter the value, or so the experts say.
The clock movement was completely disassembled and cleaned in an Ultra Sonic cleaner. all pivots were resurfaced and polished on the Watch Makers lathe, 6 new bronze bearings were installed into worn pivot holes. I use the more expensive bronze bushings simply because they are harder and last longer than brass bushings. All bushing work in done by hand not with a drill press or bushing machine. This ensures the bushings are the correct size and are installed perpendicular. Once installed the interior of the bushing is polished with a smoothing broach and the oil sinks are hand cut into the front of the new bearing, the back side is cut to remove troublesome burrs. All metal to metal wear was eliminated. The verge was hand stoned and polished with a Sapphire file then trued to the escape wheel. The clock was cleaned again in the Ultra Sonic cleaner to remove any metal particles, assembled and lubricated with the finest clock oil. The clock now runs with a very strong pendulum amplitude as it should. I run and test my clocks for 30 days prior to being offered for sale. This is what I do and have done for the last 35 years. As a clockmaker, all work is performed to the highest Horological standard.
Basic Information You Should Know!
For those of you who are not familiar with the term "Restoration", this simply means cleaning, waxing and repairing a clock or any other Antique to original condition without alteration. The more an item is original the more it is worth. The less original the less it is worth. If the clock movement is changed, the Antique Value is diminished to parts only and can not be valued as an Antique.
Polishing the Brass will not alter the Antique Value of a clock.
Not everyone can afford or even appreciate this level of restoration. However, that is no reason to perpetuate the misrepresenting and dishonesty by other clock sellers. There is a perfectly good reason why clock sellers will not show you the clock mechanism. #1 their clock is dirty, badly worn and probably not original to the case. #2 if it is shown it does not look like my clock movements. #3 The latest deception is that sellers are taking a photo of the movement with a bright flash giving the illusion that the brass movement is clean and bright. Saying that a clock is running good does not mean it will keep accurate time.
Many internet clock sellers claim that they guarantee the clock runs, however when the clock arrives it will not run. When the seller is contacted he simply passes the buck to the shipper that it was damaged in shipping and you the buyer should file a insurance claim. This gets him off the hook for selling a clock that was not in good order to begin with. WARNING, If not packed properly the shipper will refuse the damage claim. Sound Familiar? My properly restored original Antique Clocks will provide years of uninterrupted service and pleasure. Hope this little tidbit of information aids you in making an intelligent decision on what to buy or NOT. All my clocks come with a correct fitting key, a set of instructions specific to this clock and the best packing in the business. I expect you to take the clock out of the box and have it up and running in a short time and I am here to support you .
At Drury House Antiques I offer over 80 restored Original Antique Clocks, To purchase with MC or VISA please call Drury House Antiques 802-824-4395 EST or use PAYPAL We do all of our own packing and will work you to find best service and rates available.
Need Help With Your Drury House Order Call 802-824 4395 EST Between 8AM - 8PM
After Christmas Sale, Final Days, Marked Sale Price is UP- TO 50% OFF on 1500 Antiques Clocks, Collectibles, Advertising